Logic Corp - Improved molding efficiency


Read articles about water transfer, venting and other topics of interest.

See what customers think about our products and customer service. Want to have your testimonial posted? Email us at logic@logicseal.com

Specials & Discounts

Discounted Units & Special Deals.


Phone: (203) 598-3400
Toll Free: (800) 325-6442

Fax: (203) 598-3401
email: Info@logicseal.com
Inventor of the Logic Seal


Model VT-1800-3 Three Phase

  • 22 GPM, Closed-loop Negative Pressure System
  • 1 ½ HP Pump
  • Digital Dual Readout Temperature Controller
  • Safety Disconnect on Incoming Power
  • Motor Starter Relay
  • Electronic Overload Protection on Motor
  • Pump Reversal Protection with Indicator Light (Phase Monitor)
  • Available Voltage: 208-240, 308-415, 460-480 (120 volt Control Circuit)
  • All Electrical Components are UL/CE/CSA Rated
  • Pre-Vac Switch (to prevent unwanted pressure TO Mold before start-up)
  • Liquid Filled Gauges: Air Reservoir/Cooling Supply and Cooling Return
  • All Copper and Bronze Plumbing
  • Stainless Steel Reservoir Tank
  • Automatic Filling (filling and maintaining fluid)
  • Low Watt Density Heaters (Maximum Temperature of 200°F, Maximum Temperature will vary depending on pressure, using water)
  • Logic’s Air Separation & Removal System with Indicator Lights
  • 3.2sq ft Heat Exchanger
  • Powder Coated, Ventilated Steel Cabinet
  • Bonded Rubber Casters
  • Port sizes: 1¼” NPT FROM Mold; ¾” NPT: TO Mold, Air Reservoir/Cooling Supply and Cooling Return
  • Separate Fill Port
  • Cabinet Size: 14"L x 24"W x 33"H
    Weight: 180 lbs.

    Ship Weight: 220 lbs
    Ship Size/Pallet: 14"L x 24"W x 33"H
    Ships: Class 70, Common Carrier, Do Not Stack
    NMFC# 133300-08

    Specifications subject to change without notice. "Vac-U-Temp" is a trademark of Logic Corporation. The Vac-U-Temp temperature controller/leakstopper U.S.Patent #4,287,941.

© 2009 All rights reserved. Logic. Copyright information