CONDENSED EQUIPMENT SPECIFICATIONS
MODEL VT-1800 Vac-U-Temp
- 22 gpm, Closed-loop Negative Pressure System, .75 HP Pump
- Digital Dual Readout Temperature Controller
- Circuit Breaker on Incoming Power
- Motor Starter Relay
- Electronic Overload Protection on Motor
- Pump Reversal Protection with Indicator Light (Phase Monitor)
- Avail.Voltages: 208-240/8 Amps, 460-480/4 Amps, (120 volt control circuit)
- All Electrical Components are UL/CE Rated
- Pre-vac Switch (to prevent unwanted pressure to the mold before start-up)
- Liquid Filled Gauges: TO MOLD, FROM MOLD, COOLING SUPPLY, AIR SUPPLY
- Copper and Bronze Plumbing
- An estimated 4 Gallon Stainless Steel Reservoir Tank
- Automatic Filling (filling and maintaining fluid)
- Low Watt Density Heaters (Maximum Temperature of 200°F, Maximum Temperature will vary depending on pressure, using water)
- Logic’s Air Separation & Removal System with Indicator Lights.
- 3.2 Sq. Ft. Heat Exchanger.
- Powder Coated, Ventilated Steel Cabinet
- Bonded Rubber Casters.
- Port sizes: 1” NPT FROM MOLD,
3/4" NPT: To MOLD, AIR/RESERVOIR/COOLING SUPPLY and COOLING RETURN
CABINET: L:14" W:24" H:33" WEIGHT: 180 lbs.
Approximate Ship Weight: 220 lbs
Ship Size / Skid : 30"L x 40"W x 39"H
Ship: Class 70, Freight Carrier Do Not Stack
NMFC#133300
Specifications subject to change without notice. "Vac-U-Temp" is a trademark of Logic Corporation. Vac-U-Temp temperature controller/leakstopper U.S.Patent #4,287,941.
|