Logic Corp - Improved molding efficiency

 


Articles
Read articles about water transfer, venting and other topics of interest.

Testimonials
See what customers think about our products and customer service. Want to have your testimonial posted? Email us at logic@logicseal.com


Specials & Discounts

Discounted Units & Special Deals.
 

 


Phone: (203) 598-3400
Toll Free: (800) 325-6442

Fax: (203) 598-3401
email: Info@logicseal.com
Inventor of the Logic Seal

CONDENSED EQUIPMENT SPECIFICATIONS

MODEL VT-4000 Vac-U-Temp

  • 50 gpm, Closed-loop Negative Pressure System, 1.5 HP Pump
  • Digital Dual Readout Temperature Controller
  • Circuit Breaker on Incoming Power
  • Motor Starter Relay
  • Electronic Overload Protection on Motor
  • Pump Reversal Protection with Indicator Light(Phase Monitor)
  • Avail.Voltages:208-240/28.2 Amps,440-480/16.1 Amps(120 volt control circuit)
  • All Electrical Components are UL/CE Rated
  • Pre-vac Switch(to prevent unwanted pressure to the mold before start-up)
  • Air Mold Purge Valve(reduces fluid loss by removing fluids from mold & hoses)
  • Liquid filled Gauges: TO MOLD, FROM MOLD, COOLING SUPPLY, AIR SUPPLY
  • Stainless Steel and Copper Plumbing
  • An estimated 5.27 Gallon Stainless Steel Reservoir Tank
  • Automatic Filling (filling and maintaining fluid level)
  • 3.2 Sq. Ft Heat Exchanger, with a constant flow of coolant supply to maintain the cold fluid reservoir in the Heat Exchanger while process fluid in tank remains at set point
  • Low Watt Density Heaters for a Maximum Temperature of 400° F (using approved transfer fluid under negative pressure)
  • Powder Coated, Ventilated Steel Cabinet
  • Bonded Rubber Casters
  • Port sizes: 1-1/4" NPT: TO MOLD and FROM MOLD, 3/4" NPT: AIR, RESERVOIR, COOLING SUPPLY and COOLING RETURN

CABINET SIZE: L:14" W:24" H:33" WEIGHT: 225 lbs.

Approximate Ship Weight: 265 lbs
Ship Size / Skid : 30"L x 40"W x 39"H
Ship: Class 70, Freight Carrier Do Not Stack
NMFC#133300

© 2009 All rights reserved. Logic. Copyright information